Amphenol eco|mate Connector
The eco|mate series' array of products is specifically designed for industrial applications. Rough conditions pose no problems for the eco|mate connector. The flexible design offers many economic advantages.
The Amphenol -Tuchel eco|mate product range offers a program that completely fulfils any requirement specifications. The appealing design of the eco|mate series offers many advantages regarding handling and processing. Thus, the grasping range of the screw locking parts was arranged ergonomically and to
be dirt resistant for a simple connection release, even under the most difficult environmental conditions.
The demands upon connectors being used for industrial application call for a rugged design, an appropriate protective category (min. IP 65), an integrated cable retention, the ability to process differing cable diameters and wire gauges, as well as the possibility of screening over any residual frequencies.
Further needs of the Operator require efficient processing of the cable and receptacle connectors. Therefore, few individual parts and an exceptional termination are needed.
The cable housing is newly-developed with regards to the design and cable output. The housing is equipped with a non-sensitive metric Trapezoid thread (in accordance with DIN), which takes large voltages and also facilitates quick and easy assembly. Furthermore, a new clamping ring was developed, which protects the sealing around the cable housing and which, through a special design, enables higher cable output forces. For this reason, output forces of the value demanded by DIN 0627, can be achieved.
Finely-joined and flexible fins at the Cable output facilitate a larger cable clamping-range from 6-12.5mm in diameter. Amphenol - Tuchel has also optimised the male and female receptacles with the new design. With identical mounting dimensions as the existing C-16-1 series, mounting is possible over the ears of the protective cap of the housing. In this way, the costly production of the protective caps can be dispensed with by means of a power screwdriver.
A construction process is also in preparation for the rear-panel and for the male and female receptacle locking-process. The handler, therefore, has the possibility of assembling the respective connector before the installation. This mounting method is simple and saves time, as this way, only one panel cut-out must be manufactured.
Contact Details and Archive...
Related Articles...